RAMAPO HARDWARE -

There are 3 main sections of our Plumbing Department:
TOILET SUPPLIES
SINK SUPPLIES
TUB/SHOWER SUPPLIES
Scroll below these 3 sections to see the rest of our
plumbing supplies for appliances, garden hose
equipment, and other kinds of plumbing pipe.

TOILET SECTION
Toilet Plunger & Toilet Snake
Most toilet clogs are very shallow and usually where the first curve in the toilet drain begins.  The drain pipe becomes larger below the toilet so most toilet clogs are not deep.

Do NOT use any chemicals to unclog a toilet
You are more likely to crack the toilet than unclog it
due to the amount of heat those chemicals produce.

A plunger is always a first step for a toilet clog and if it is not doing the job then a toilet snake is the next step.
Toilet Plunger

Most people use the wrong plunger for a toilet.  Make sure your toilet plunger has an extra rubber flap sticking out of the bottom to actually go into the hole of the toilet bowl.
* Flat Sink/Tub Plungers are meant to go over a drain hole, not into it *


Toilet Plunger

$6.95




Toilet Snake

Light Duty Snake - $9.95

Heavy Duty Snake - $21.95

Toilet Seats - Mayfair Brand







White Wood Toilet Seat - $18.95
Elongated White Wood Toilet Seat - $22.95

Off-White Wood Toilet Seat - $18.95
Elongated Off-White Wood Seat - $22.95

Clean with *WATER ONLY*
Chemicals can wear away paint quickly on wooden seats
Plastic seats are not durable which is why we do not carry them in the store but we can custom order them for you.

Toilet Handles
To figure out which toilet handle you need, first check where the hole for the handle is.
FRONT Handles are considered standard
SIDE Handles are different angles depending on which company it is so check which brand toilet you have.
CORNER Handles are handles that are installed on the
corner of the toilet instead of the front or side.

Front-Mounted
Toilet Handles

$5.95


Side-Mounted
Toilet Handles

$9.95



Corner-Mounted
Toilet Handles

$9.95


Toilet Flappers


KORKY (Regular)
Flappers

$4.95




TOTO (Large) Flappers

$12.95








KOHLER Flappers

$2.95




Toilet Fill Valve

This mechanism is the on/off switch for filling the tank.
Once the tank is full, the black
float is pushed up by the water
and turns off the valve.
$10.95

* There is also a black rubber hose that connects the
fill valve to the overflow pipe of the flush valve *

Toilet Flush Valve

This is the other tall pipe inside of most toilets.  This is the pipe that the rubber flapper attaches to at the bottom to cover the hole and keep water in the tank.



$6.95








(More Coming Soon)
SINK SECTION


Sink and Tub Snake

Most effective way of
unclogging sink drains.
8 feet long - $5.95
15 feet long - $9.95
25 feet long - $15.95




DRANO Dual
Force Foamer

Effective for lighter clogs
Use a snake for heavier clogs

$6.95




FAUCETS


DELTA Kitchen Faucet
Double Handle
8 inch base
Comes with Deck Spray









DELTA Bathroom Faucet
Double Handle
4 inch base




DECK SPRAY SUPPLIES




DELTA Deck
Spray Kit







Deck Spray Head







Deck Spray Hose











Deck Spray Guide



Deck Spray Hole Cover











(More Coming Soon)
SHOWER/TUB SECTION (Coming Soon)

The rest of our plumbing department focuses on things for washers, dryers, ice makers, tips on installing a bidet, and other miscellaneous plumbing items.

Washer/Dryer & Stove/Gas Range Supplies
 
Gas Lines
Stainless Steel - Includes adapters on both sides
Available in the following sizes:
3' -$17.95
4' - $20.95
5' - $25.95
6' - $27.95

Gas Line Adapters - $3.95
(Used to connect Gas Lines to a dryer or Stove)
There are two main flare sizes and we only carry one: (Measures about 7/8")
Flare x 3/8" Female Pipe Thread
Flare x 1/2" Male Pipe Thread
Flare x 1/2" Female Pipe Thread
Flare x 3/4" Male Pipe Thread
Flare x 3/4" Female Pipe Thread

 Flare = ROUNDED EDGE at the tip
 
Safety Tips for Proper Gas Line Installation
  • Seal threads with yellow teflon tape or teflon paste
  • Do NOT seal threads with white teflon tape (white is for water only, not gas)
  • Screw the adapters onto each side first and then attach the flexible pipe last
  • Test for gas leaks using a mixture of soap & water
 
 
Flexible Aluminum Foil Duct
 (For Dryer Air Exhaust)
 
4" Diameter
 
 
8' -$9.95
20' -$19.95
25' - $21.95
 
 
 We can custom cut any size too!
$1.55 per foot
 
We also carry:
4" Dryer Clamps, Dryer Elbows, and Dryer Couplings
 
BLACK PIPE (Gas Only)
We do not carry Brass or Galvanized (Both are used for water)
Except for 1/2" x Close Brass or 1/2" x 1 1/2" Brass

Pipe (Nipples)
1/8"
1/8" x Close - $0.50
1/8" x 1 1/2" - $0.75
1/8" x 2" - $0.80
1/8" x 3" - $0.98
1/8" x 4" - $1.15
1/8" x 6" - $1.95
1/8" x 8" - $2.95
1/4"
1/4" x Close - $0.65
1/4" x 1 1/2" - $0.75
1/4" x 2" - $0.80
1/4" x 3" - $0.98
1/4" x 3 1/2" - $1.55
1/4" x 4" - $1.85
1/4" x 5" - $1.95
1/4" x 6" - $2.25
1/4" x 8" - $2.95
3/8"
3/8" x Close - $0.70
3/8" x 1 1/2" - $0.75
3/8" x 2" - $0.80
3/8" x 2 1/2" - $0.90
3/8" x 3" - $0.98
3/8" x 3 1/2" - $1.55
3/8" x 4" - $1.25
3/8" x 5" - $1.95
3/8" x 6" - $2.25
3/8" x 8" - $2.95
3/8" x 12" - $3.95
1/2"
1/2" x Close (BRASS) - $2.45
1/2" x 1 1/2" (BRASS) - $2.95
1/2" x Close - $0.70
1/2" x 1 1/2" - $0.75
1/2" x 2" - $0.80
1/2" x 2 1/2" - $0.90
1/2" x 3" - $0.98
1/2" x 3 1/2" - $0.98
1/4" x 4" - $1.25
1/4" x 4 1/2" - $1.25
1/2" x 5" - $1.35
1/2" x 5 1/2" - $1.45
1/2" x 6" - $1.55
1/2" x 8" - $2.25
1/2" x 10" - $2.95
1/2" x 12" - $3.45
1/2" x 18" - $3.95
1/2" x 24" - $4.95
1/2" x 30" - $5.95
1/2" x 36" - $7.95
1/2" x 48" - $9.95
1/2" x 60" - $10.95
3/4"
3/4" x Close - $0.70
3/4" x 1 1/2" - $0.75
3/4" x 2" - $0.80
3/4" x 2 1/2" - $0.90
3/4" x 3" - $0.98
3/4" x 3 1/2" - $0.98
3/4" x 4" - $1.25
3/4" x 4 1/2" - $1.25
3/4" x 5" - $1.35
3/4" x 5 1/2" - $1.45
3/4" x 6" - $1.55
3/4" x 8" - $2.25
3/4" x 10" - $2.95
3/4" x 12" - $3.95
3/4" x 18" - $5.95
3/4" x 24" - $6.95
3/4" x 30" - $7.95
3/4" x 36" - $8.95
3/4" x 48" - $10.95

Caps
1/8", 1/4", 3/8", 1/2" & 3/4" - $0.98

Couplings
1/8", 1/4", 3/8", 1/2", & 3/4" - $1.25

Elbows (90 Degrees)
1/8", 1/4", 3/8", 1/2", & 3/4" - $1.25

Elbows - Street Elbow - (90 Degrees)
1/8", 1/4", 3/8", 1/2", & 3/4" - $1.25

Elbows - (45 Degrees)
1/8", 1/4", 3/8", 1/2", & 3/4" - $0.98

Plugs
1/8", 1/4", 3/8", 1/2", & 3/4" - $0.85

Reducers (Male x Female - Bushing)
1/8" M x 1/4" F -$0.98
1/4" M x 1/8" F -$0.98
3/8" M x 1/4" F - $0.98
1/2" M x 1/8" F - $1.25
1/2" M x 1/4" F - $1.25
1/2" M x 3/8" F - $1.25
3/4" M x 1/4" F - $1.25
3/4" M x 3/8" F - $1.25
3/4" M x 1/2" F - $1.25
3/4" M x 1" F - $1.25

Reducers (Female x Female - Bell Type)
1/4" x 1/8" - $0.98
3/8" x 1/8" - $0.95
1/2" x 1/4" - $1.25
1/2" x 3/8" - $1.25
3/4" x 3/8" - $1.25
3/4" x 1/2" - $1.25

Tees
1/8", 1/4", 3/8", 1/2", & 3/4" - $1.55

Unions
3/8", 1/2", & 3/4" -$2.95

Valves
1/2" Gas Valve - $5.95
3/4" Gas Valve - $8.95

(More Coming Soon)